EPDM Single – Ply Roofing Systems Part 1

EPDM Single – Ply Roofing System

EPDM: Ethylene Propylene Diene Monomer (or Terpolymer which is simply a product consisting of three distinct monomers).  EPDM is classified as a Thermoset material which means it is either fully-cured prior to being installed or that it cures during natural weathering after installation.  EPDM roofs are single-ply membranes meaning there is only one ply of roofing material, not multiple plies laminated together.

EPDM has been in use on roofs in the USA since the 1960’s and is one of the most common types of low-slope roofing materials.  This is because it is relatively inexpensive, simple to install, and fairly clean to work with when compared to conventional built-up roofs.  There aren’t the odors and fumes that accompany built-up roofs which appeals to many property owners and managers.

EPDM is a rubber material whose principal components consist of the compounds ethylene and propylene.  A flexible rubber matrix forms when a small amount of diene is added to the mix.  EPDM is available reinforced or unreinforced with both commonly used; it’s also available in either a cured (vulcanized) or uncured (non-vulcanized) state. Vulcanized EPDM is the most common with non-vulcanized often used for flashing purposes.

EPDM membrane thickness ranges from thirty mils (0.030″) to one-hundred mils (0.100″) with the most common thicknesses being forty-five mils (0.045″) and sixty mils (0.060″).  There are three standard application procedures:
(1) fully-adhered
(2) mechanically-fastened
(3) loose-laid

Fully-adhered EPDM uses water or solvent-based adhesives to adhere the rubber to the substrate.  Mechanically-fastened EPDM is attached by manufacturer-approved mechanical means to the substrate, and loose-laid membranes are secured only at the perimeters and any penetrations.  A ballast of round river rock or concrete pavers is used to hold the materials in place.  River rock is usually installed at a rate of 1000 – 1200 pounds per roof square (100 square feet) and the pavers generally weigh approximately 20 pounds per square foot.  Structural integrity is important with loose-laid roof systems.  The seams of all systems are then sealed using either an adhesive or a splice tape.  Splice tapes have tested with a higher tear-strength.

Advertisements

Tags: , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s


%d bloggers like this: